When I check the settings in the vMix Audio Mixer for each of my audio devices, I see that the Master Audio and Bus A indicate 48000 Hz 16 Bit 2 Channels, but my Blue Yeti Microphone and Audio Line 2 inputs indicate 48000 32 Bit Float 2 Channels. I saw somewhere on Facebook that the bitrates need to match among all audio devices in vMix. (I've not had to use virtual audio cables though). In Wirecast, I've been doing screen captures of Zoom on a second monitor connected to this same PC and have not had any audio issues. Windows indicates my Realtek sound card driver is up to date.

My system configuration: Windows 10, i7-6700 quad core processor, 16 GB RAM, nVidia 750-TI graphics card. In Settings > Speaker: Line 2 Virtual Audio Cable In Settings > Audio > Microphone: Line 1 (Virtual Audio Cable) In Add Inputs > Audio Inputs: Audio Device: Line 2 Virtual Audio Cable Audio Device: Blue Yeti USB Microphone

In Settings > Audio Outputs: Master Output: Enabled Headphones: Realtek High Definition Audio Bus A: Line 1 (Virtual Audio Cable) Bus B: None Default Bus for New Inputs: Master

I'm trying to bring in a remote guest via Zoom into vMix using Virtual Audio Cables for the audio and keep getting a crackling sound over that cable. I've searched the forum but have not found an answer to this question. I'm new to vMix (just started using version 20 as a trial) but have been using Wirecast for about 10 months.

Virtual audio cable vac